This ergonomic C-Frame combines a sturdy and high quality design. After welding, our C-Frames are then milled to the jack locking plates fixings and the test table in order to correct any misalignment due to welding !
Standards : EN 12390-5
Developped in partnership with the polystyrene producers association, the RP5 PSE machine is already in use in more than 50 polystyrene infiller block factories.
This cros-beam type flexural frame is available in 4 different load capacities : 80, 110, 150 and 200 kN.
Aimed for pre-stressed or reinforced concrete beam manufacturies, our press machines allow that only one operator realises the different tests in automatic mode, including the load stages required in accordance to the EN 15037-1.
